ESP32 Ausgang auf 40mA Strom einstellen
Arduino, Strom, Treiber, MosFET
GPIO Ausgang Strom anpassen
Beim ESP32 kann man die maximale Stromstärke im Prozessor anpassen.
Ein Digitaler Ausgang wird beim ESP32 normalerweise mit 20mA Milliampere belastet.
Man kann den Digitalen Ausgang aber auch auf 40mA umschalten
• 2: ~20 mA
• 3: ~40 mA
esp_err_tgpio_set_drive_capability(gpio_num_t gpio_num, gpio_drive_cap_t strength)
Set GPIO pad drive capability.
- ESP_OK Success
- ESP_ERR_INVALID_ARG Parameter error
- gpio_num: GPIO number, only support output GPIOs
- strength: Drive capability of the pad
esp_err_tgpio_get_drive_capability(gpio_num_t gpio_num, gpio_drive_cap_t *strength)
Get GPIO pad drive capability.
- ESP_OK Success
- ESP_ERR_INVALID_ARG Parameter error
- gpio_num: GPIO number, only support output GPIOs
- strength: Pointer to accept drive capability of the pad
Each digital output pin is associated with its configurable drive strength. Column “Drive Strength” in Table IO_MUX lists the default values.
The drive strength of the digital output pins can be configured into one of the following four options:
• 0: ~5 mA
• 1: ~10 mA
• 2: ~20 mA
• 3: ~40 mA
The default value is 2. The drive strength of the internal pull-up (wpu) and pull-down (wpd) is ~75 µA.
The maximum output current (sink/source) of the ESP32 is 12mA.